Regal 38 EXPRESS Manuel du propriétaire télécharger pdf (Page 98)

Systems

Operating Typical Standard Dockside Water System

At Mooring-Using Dockside Water Inlet:

1. Verify that the dockside water is pure and safe to use.

2. Locate the dockside inlet valve at the transom. Unscrew

the cap. Connect a clean hose to the vessel’s dockside water

inlet ﬁ tting and the marina dockside water supply. A 50

foot white hose (safe for carrying drinking water)should

reach most dockside faucets. Note: The dockside water

inlet valve uses a system in-line valve that keeps the water

traveling in one direction only.

3. Open the marina water supply faucet (spigot) which at

this point will distribute dockside water to the vessel.

4. It may be helpful to open an on board faucet to help

eliminate any air in the lines. Note that the pressure

pump system is not activated when using the dockside

water inlet system.

TYPICAL DOCKSIDE WATER INLET

At Sea-Using Fresh Water Pressure Pump System

1. Energize the fresh water pump breaker at the ship’s main

DC panel. This will permit water to ﬂ ow to the appropriate

faucet or component.

Note: Remember that all fresh water at sea is being delivered

through the on board potable water tank.

Therefore, it is important to periodically check the fresh

water monitor for remaining on board quanities.

PREVENT PROPERTY DAMAGE!

DEACTIVATE THE FRESH WATER

PRESSURE PUMP BREAKER AND

DOCKSIDE WATER INLET HOSE BEFORE

LEAVING THE VESSEL.

WARNING

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 316 317

Pas de commentaire

Regal 38 EXPRESS Manuel du propriétaire Page 98