Regal 38 EXPRESS Manuel du propriétaire télécharger pdf (Page 87)

Chapter 4

Fuel Filter Element Overview-Gas Generator

Since water is heavier than fuel it will settle in the bottom of

the element. Periodically replace the fuel ﬁ lter element With

a strap or ﬁ tted wrench turn the element counterclockwise

until loose. Unscrew by hand and release from the ﬁ lter

body. Use an environmentally safe container to catch any

contaminated fuel. Dispose of according to local or state

regulations.

Coat the O ring (gasket) of the new element with oil. Hand

tighten by turning clockwise until tight.

Note: Water in gasoline or diesel fuel will gather at the

bottom of the container. Since it is heavier water will

normallly appear as a different color and consistency and

normally can be spotted as in moves back and forth.

Run blower for at least 4 minutes. Start engine and check

for leaks.

FILTER

ELEMENT

FILTER

BODY

TYPICAL GENERATOR GAS FUEL FILTER

Typical Electrical System

The generator starting system normally uses the port

cranking battery. The generator is usually started at the 12

volt ship’s control panel located in the salon but it can also

be started using the remote instrument panel located at the

generator itself as needed. The latter is especially useful

while maintenance is being conducted. The generator

remote instrument panel features temperature, oil, DC

volts, hour meter gauges and pre-heat, start and stop

switches. The starting switches can be reached through an

access panel at the sound shield.

One of the switches is set up different on the ship’s main

control panel. Here the pre-heat switch is called an “on”

switch. The start and stop switches by name and function

are identical to the switches on the remote panel.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 316 317

Pas de commentaire

Regal 38 EXPRESS Manuel du propriétaire Page 87