Regal 38 EXPRESS Manuel du propriétaire télécharger pdf (Page 131)

Engine & Controls

ENGINE MOUNTS

The engines are placed in the boat on a set of metal or

wooden platforms called mounts. These rubber isola-

tion mounts keep the engine from moving laterally and

athwartships (right angles to the center line). The mounts

help reduce the vibration caused by the engine and drive.

Periodically, the mount hardware should be checked for

tightness by your authorized Regal dealer.

ENGINE ALIGNMENT

Selected stern drives use a rubber splined hub to which

the stern drive shaft is attached. There is an alignment

speciﬁ cation between the engine and stern drive that

needs to be checked periodically. A special alignment

shaft is greased at the tip and inserted through the gim-

bal housing with the drive unit removed from the vessel.

The alignment angle can be determined by the spline im-

age left on the tool. The engine mounts are then adjusted

to obtain a spline image mirrored 360 degrees around

the greased alignment tool. This speciﬁ cation should be

checked after each 50 hours of operation or if the vessel

has run aground or hit a submerged object. Alignment

should be checked by a Regal dealer or marine profes-

sional since a special tool and procedure is required. Refer

to your engine manual or contact your authorized Regal

dealer for additional information.

ENGINE REMOVAL

In the event the engine requires major service and needs

to be removed, consult your Regal dealer. The dealer pos-

seses the knowledge,factory training and special tools

necessary to accomplish such a job. Do not undertake

this type of repair yourself.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 316 317

Pas de commentaire

Regal 38 EXPRESS Manuel du propriétaire Page 131