Regal 38 EXPRESS Manuel du propriétaire télécharger pdf (Page 146)

Chapter 6

STARTING ENGINES

Position the remote control handles in the neutral position.

Keep passengers seated and away from controls.

Note: With earlier models the Volvo EVC-D control

station will be activated once the ignition key is in the

“ON” position (key position l) At this point the neutral

“N” icon will display a green light .

Next, turn the key to the start position (key position lll).

You will hear the starter cranking over the engine. When the

engine starts release the key switch. If additional cranking

attempts are needed, the key must be returned to the 0

position ﬁ rst.

If the engine does not start, refrain from cranking the

engine over 10-12 seconds. Allow the starter and battery

a chance to recover. Advance the remote control in the

neutral throttle position only as recommended in the

engine manual. Do not race the remote control in the

neutral position.

On later EVC-D systems, turn the key to the “ON”

position and then to the start position. Release the key. The

starter will continue to crank until the engine starts.

With this system once the keys are engaged in the automatic

start position they are disengaged if you try to turn them

again to the start position.

On the newest Volvo engines a key fob system is used

to start the engines. The system uses two main parts; the

key panel and the key fob. Two key fobs come with dual

engine installation along with a 2.5” key panel. The key

panel uses lighted icons to show active ignition and start/

stop positions. Theft protection is vastly improved with

the E-key system.

If the starter stays engaged for more than 30 seconds

the circuit is automatically cut to protect the starter from

overheating. If this happens, let the starter cool for several

minutes before attempting to restart the engine.

Note: With all the above systems, refer to the Volvo

operator’s manual for further information.

STARTING & STOPPING

The following general information covers

starting and stopping your engines.

Read and understand all previous

information on remote controls, fueling

and operational procedures. Pay particular

attention to all labels. Refer to the engine

operation manual for in-depth propulsion

system information.

Review all pre-departure information. Before starting

your engines make sure all canvas is removed and stored.

Start engines only in a well ventilated location to avoid

diesel exhaust buildup. Make sure all battery switches are

activated. Close and lock the center windshield section.

AVOID PERSONAL INJURY OR DEATH!

WHEN ENGINE IS RUNNING

TRANSOM DOOR MUST

BE CLOSED AND LOCKED.

SWIM PLATFORM

AND LADDER MUST NOT BE IN USE.

WARNING

AVOID SERIOUS INJURY OR DEATH!

THE OPERATOR OF THE CRAFT

MUST HAVE COMPLETE CONTROL

OF THE HELM STEERING STATION

WHILE THE VESSEL IS MOVING.

NEVER LEAVE THE HELM

STEERING STATION UNATTENDED

WHILE THE VESSEL IS MOVING.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 316 317

Commentaires sur ces manuels

Pas de commentaire

Regal 38 EXPRESS Manuel du propriétaire Page 146

Commentaires sur ces manuels

Produits connexes et manuels pour Non Regal 38 EXPRESS